Empire DVP Series Installation Instructions

LINER KITS FOR USE WITH DVD, DVCD, DVP, AND DVX SERIES FIREPLACES
INSTRUCTIONS MUST BE LEFT WITH OWNER FOR FUTURE REFERENCE AFTER INSTALLATION.
1. Using gloves, unpack liner components and check for
damaged or missing components.
2. Lower bottom louver and remove upper louver on fireplace.
3. Remove glass fame assembly from fireplace.
4. Remove top twig(s) and rear log(s) from burner assembly.
5. For DVD, DVCD and DVP series fireplaces only, place the
top brick panel into brick panel holder. With needle-nose
pliers, carefully bend hold-down tabs on brick holder over
the edges of the top brick panel. The hold-down tabs will
secure the top brick panel in place.
6. Place brick panel (rear) against rear wall in fireplace.
NOTICE: The top edge will have a half-moon cutout relief
to match up with the rear flue vent hole (DVD, DVCD and
DVP Fireplaces only).
NOTICE: For some liner installations in the DVD48FP
Fireplace, the Rear Liner panel has two small legs that
are to be placed at the back left and right corners of the
firebox. The two legs support the rear liner panel.
NOTICE: (A)DVX Series fireplaces do not include a top
liner panel. For these models only, remove the upper flue
baffle which is secured to the inside top of the firebox with
two screws.
LEFT
SERIES FIREPLACES
21713-5-0220
INSTALLATION INSTRUCTIONS
DVP SERIES LINER KITS
TOP
RIGHT
BACK
HERRINGBONE
DVD/DVCD/DVP
LEFT
DVX SERIES FIREPLACES
( NOTICE:
Empire Comfort Systems, Inc. • Belleville, IL
NOTICE: On (A)DVX Series fireplace, orient the back liner
panel so the three small square relief holes on the back
of the panel are at the bottom. To secure the back panel
in position, re-install the upper flue baffle with two screws.
ATTENTION: Herringbone left panel has L stamped in
upper, left corner. Herringbone right panel has R stamped
in upper right corner.
7. To install side brick panels, align grout lines on side
brick panels with the grout lines on the back brick panel.
NOTICE: On DVX models, secure top of each side panel
with one top retainer bracket and screw.
8. Replace rear log(s) and twig(s) onto burner assembly.
Refer to log placement in the installation instructions and
owner's manual for proper placement.
9. Replace the glass frame assembly onto the fireplace.
10. Raise bottom louver and replace top louver onto fireplace.
11. Installation of optional brick liner is complete.
12. If there is any damage to any panel, the whole kit should
be replaced in order to maintain proper color match.
LEFT
BACK
RIGHT
BRICK PATTERNS REMOVED)
TOP
RIGHT
BACK
AGED BRICK
DVD/DVCD/DVP
SERIES FIREPLACES
Page 1