Advertisement
location to access every 6 months for
replacement. We suggest that this
location is beside the water filter supply
faucet in a cupboard beside the
refrigerator.
• A minimum clearance of 2 1⁄2" (64 mm)
from the bottom of the filter cartridge is
required to perform cartridge removal.
• Do not screw water filter to refrigerator.
11. Attach double sided foam to the back of the
water filter head as shown in Diagram 5. Write
the date to be replaced on the filter (date
installed + 6 months). Remove the double sided
foam backing and attach the filter to the desired
position, reinforcing the filter with the screws
provided as located in step 10 (refer to the
previous page).
12. Run the 1⁄4" (6 mm) tubing to the back of the
refrigerator ensuring there is enough tubing to
pull the refrigerator out for service.
13. Using the measurement guide located on the
rear compartment cover as shown in Diagram
6. Mark out 5⁄8" (16 mm), on the end of the
tubing as shown in Diagram 7.
14. Insert the tubing marked 5⁄8" (16 mm) into the
water (solenoid) valve up to the marked line as
shown in Diagram 8.
15. Pull gently on tubing to ensure it is locked in as
shown in Diagram 9.
16. The completed installation should look like
Diagram 11 on page 16.
17. Turn the isolating faucet on and check that all
connections are dry and free of drips.
https://producthelp.fisherpaykel.com/us/Cool/Fridges/Bottom_Freezer/Without_Ice_and_Water/13.5_cu_ft/RF135BDRX4/User...
Diagram 4 - Locking Key
Diagram 5 - Double sided Foam Attachment
Updated: Tue, 02 Jun 2020 23:55:17 GMT
Powered by
14
Advertisement
