Advertisement
Please read all the instructions before assembly
Height Adjusting Method
Figure 5
The wheel height can be adjusted to a
maximum of 15mm.
To adjust the table height at wheel, screw part
A (as seen in figure 5) anti-clockwise to raise
the table, and Part B clockwise to lower it.
All feet can be adjusted slightly to ensure a level playing surface.
Note on Safety
•
The table tennis table should be used only for its intended purpose. All other uses may be
dangerous. The manufacturer cannot be held liable for damage or injury caused by improper
use of the table.
•
Instruct others (particularly children) of any potential source of danger, especially when
folding and unfolding the table. We recommend this is done by adults.
•
The table tennis table should only be moved in the transport position as otherwise may cause
injury.
•
Depending on frequency of use, check all screws, bolts etc. regularly to ensure that they are in
good condition.
•
Caution: while assembling the product, keep out of the reach of children (choking hazard –
contains small parts)
•
For any further information, please contact your KNIGHT dealer.
•
Do not use the table tennis table until it has been fully and correctly assembled and checked.
•
Do not use corrosive or abrasive materials to clean the equipment. In most cases, a very
slightly moist cloth is sufficient. There are specialist cleaning sprays available from most
good retailers.
www.knighttablesport.co.uk
Email: sales@knighttablesport.co.uk
The foot height can also be adjusted to
a maximum of 15mm.
To adjust table height at the foot, screw foot
anti-clockwise to raise the table, and clockwise
to lower it.
Page 3 / 3
Advertisement
