Ignition System - Husqvarna H130 Mark II Workshop Manual

11.1 Test the ignition system
If there is a fault in the ignition system the ignition
module must be tested before the ignition system is
removed. See chapter 20.
11.2 Dismantling
1. Remove the cylinder cover and the starter unit.
2. Remove the spark plug cable from the spark plug.
Remove the spark plug.
3. Remove the air filter and the air filter holder. See
chapter 8 Start/stop switch.
4. Remove the ignition cable from the start/stop switch.
5. Loosen the two screws and remove the ignition
module. See Figure 1.
Cleaning and inspection
11.3
Clean and inspect all parts carefully. If there are any
cracks or other defects replace the damaged parts with
new ones. Always use original parts.
11.4 Assembly
1. Attach the ignition module to the cylinder without
tightening the screws. See Figure 1.
2. Turn the flywheel so that the magnets are in line
with the ignition module. Fit the the plastic feeler
gauge (502 51 34- 02). Set a distance of 0.3 +/- 0.1
mm, between the ignition module and magnet. The
measurement applies to the two lowest lugs on the
ignition module. Tighten the screws. See Figure 2.
3. Pull the ignition cable through the hole as outlined in
Figure 3.
4. Attach the ignition cable to the start/stop switch. See
Figure 3.
5. Attach the air filter holder to the carburettor. Attach
the air filter.
6. Attach the starter unit.
7. Attach the spark plug cable to the spark plug.
8. Attach the cylinder cover.

11 Ignition system

Fig. 1
Fig. 2
Fig. 3
Air gap tool
Ignition system
English - 23