InSTALLATIon InSTRUcTIonS
TooLS neeDeD
•
7/16" Wrench
LocATIon ReqUIReMenTS
•
The stand must be installed on a solid floor. A concrete floor is best.
•
The floor should be level.
•
A suitable location is protected from direct sunlight and heat sources such as
radiators, baseboard heaters, or cooking appliances.
•
Do not install on carpeting.
•
The location must have appropriate electrical and gas supply outlets. See the
"Electrical & Gas Supply Requirements" section in your product's User Manual.
•
Do not install in a location where the dryer might come into contact with
combustible materials such as, but not limited to curtains, thick carpet, and/or
any materials that might obstruct ventilation.
STAnD DIMenSIonS
(124.5 cm)
4
•
49
"
24½ "
(62.2 cm)
Phillips screwdriver
75
(190.5 cm)
22
"
(55.9 cm)
"