Related Manuals for BRUNEL JSE.5-0104MAEAD
Summary of Contents for BRUNEL JSE.5-0104MAEAD
- Page 1 World Leader in Modular Torque Limiters Installation and Maintenance Instructions JSE.5-0104MAEAD Extruder Clutch 1304 Twin Oaks Street · Wichita Falls, Texas 76302 · (940) 723-7800 · Fax: (940) 723-7888 E-mail: sales@brunelcorp.com · www.brunelcorp.com...
-
Page 2: Installation
Installation and Maintenance Instructions JSE.5-0104MAEAD Extruder Clutch 1. INSTALLATION a. Coupling should be installed with pins/buffers removed. 11.035’’ b. Apply an anti-seize compound to the gearbox input shaft. c. Slide gearbox coupling half (1-1) onto gearbox shaft. d. Slide motor hub onto shaft. -
Page 3: Torque Adjustment
Installation and Maintenance Instructions JSE.5-0104MAEAD Extruder Clutch 6. TORQUE ADJUSTMENT 4) Using box or open end wrench, turn housing nut until the required number of setting marks from “zero” are obtained. a. To adjust torque at the job site: Prior to setting Safety Elements 5) Turn Set Screw (2-20) until tight. - Page 4 d. Group shims to obtain a shim thickness ~ (0.003”-.008”) less Grease inside surfaces of the Housing and install Outer than measurement in above. Thrust Race (2-2) and “O” Ring (2-14). e. Remove Safety Element assembly, install shims of correct Grease Plunger (2-1 ) and install thru Housing and Outer thickness and re-install Safety Element assembly (1-14).
- Page 5 TABLE 1 Installation Max. Eflex Coupling Rigid Hub Brunel Part No. Coupling Alignment Limit Tightening Torque Tightening Torque Size or O.D.
- Page 7 Publication: EC JSE.5-0104 5-10 Phone: 940.723.7800 Fax: 940.723.7888 www.brunelcorp.com 1304 Twin Oaks Street Wichita Falls, TX 76302...
Need help?
Do you have a question about the JSE.5-0104MAEAD and is the answer not in the manual?
Questions and answers