Promet TC-1995 Assembly Instruction

bush for bolt
doorstep
cover
left door
damper
Door installation procedure:
1. Insert the spring axes into the roof's holes and in the holes of the doorstep cover
of the cabinet.
2. Fix the door on the lower axis.
3. Bring the upper door's angle to the axis, "drown" the axis' rod and install the
door. The axis should "click" in the door's hole.
Note. Before installing the door be sure that the axis' rod goes freely into the holes, and
if necessary, clean the holes of the paint.
1. After installing the doors insert bushes for bolt into the roof's holes and into the
holes of the doorstep cover.
2. Stick the dampers on the lower and the upper parts of the left door (see picture).
The dampers can be not stuck if the lock is closed smoothly, without jamming.
Notes to the instruction.
1. Assembly sequence is specified by the ordinal number in the left bottom corner of
each picture of the assembly operation.
2. Type and quantity of the mounting products for the assembly operation are specified
in the upper left corner of its picture.
Recommendation for cabinet exploitation.
1. The cabinet installation should be implemented on a flat horizontal surface.
2. It is recommended to begin filling the cabinet (by docs etc.) from the lower part of
the cabinet.
3. It is recommended to evenly spread the weight over the shelves' surface for the
optimal load of the mounting elements.
Notes
1. Constructive changes, not noted in this instruction, are possible.
roof
axis
2
axis
1
doorstep
cover
Assembly instruction for Tool Cabinets
TC-1095 and TC-1995
TC-1995
Guidance before assembly
1. Attentively read the instruction.
2. To avoid any damages of lacquer coating, implement assembly of a cabinet on a soft
non-abrasive surface (linoleum, carpet or protective cardboard).
3. For the cabinet assembly you will need a Phillips screwdriver.
TC-1995 х 4
Left back panel
TC-1095 х 3
1
Revision level 23.01.14
TC-1095
A
Right back panel
Bolt M5
View A