Table of Contents
Advertisement
To prevent possible electrical shock, fire, or personal injury follow these guidelines:
• Read all safety information before you use the product.
• Use the product only as specified, or the protection supplied by the product can be
compromised.
• Do not use the product around explosive gases, vapor, or in damp or wet environments.
• Carefully read all instructions.
• Do not use and disable the product if it is damaged.
• Do not use the product if it operates incorrectly.
• Do not apply more than the rated voltage between the terminals or each terminal and earth
ground.
CAUTION! The electrical system to which the unit is connected must be equipped with a
20 A max automatic bipolar circuit breaker. This circuit breaker must be of the Listed type.
The minimum distance between the circuit breaker contacts must be 3 mm (0.1 in). The
circuit breaker must be provided with protection against the fault current towards the
ground (differential) and the overcurrent (magnetothermal).
Before starting any operation, make sure the power supply is disconnected.
CAUTION! Hazardous moving parts. Keep fingers and other body parts away.
CAUTION! Device installation and maintaining must be performed by specialist technical
staff only.
CAUTION! For continued protection against risk of fire, replace only with same type and
rating of fuse. Fuses must be replaced only by service personnel.
CAUTION! In order to reduce the risk of fire, only use UL Listed or CSA certified cables.
Any change that is not expressly approved by the manufacturer will invalidate the
guarantee.
The unit must not be dismantled or tampered with. The only exceptions are those
concerning the assembly and maintenance operations stipulated in this manual.
Advertisement
Table of Contents
