Advertisement
Do Not get the drill wet or use in damp or wet locations.
8
Do Not operate the drill if any parts are missing or the drill is damaged as this may cause failure and/or possible personal injury.
8
Do Not operate the drill when you are tired, under the influence of alcohol, drugs or intoxicating medication.
8
Do Not abuse the cord. never use the cord for carrying, pulling or unplugging the power tool. Keep cord away from heat, oil,
8
sharp edges or moving parts. damaged or entangled cords increase the risk of electric shock.
Always allow the tool to come to a complete stop before putting the tool down.
9
When operating the tool outdoors, use a tool suitable for outdoor use.
9
Avoid body contact with earthed or grounded surfaces such as pipes, radiators,ranges and refrigerators. There is an increased risk
9
of electric shock if your body is earthed or grounded.
Use the power tool, accessories and tool bits etc. in accordance with these instructions and in the manner intended for the
9
particular type of power tool, taking into account the working conditions and the work to be performed. Use of the power tool for
operations different from intended could result in hazardous situation.
Avoid accidental starting. Ensure the switch is in the off position before plugging in. Carrying power tools with your finger on the
9
switch or plugging in power tools that have the switch on invites accidents.
Keep cutting tools sharp and clean. Properly maintained cutting tools with sharp cutting edges are less likely to bind and are easier
9
to control.
Store out of reach of children.
9
Do Not allow untrained persons to use the tool.
8
Store all safety notes and safety instructions for future reference. The term power tool in all of the warnings listed below refers to
9
your mains operated (corded) power tool or battery operated (cordless) power tool.
2. iNtRoDuCtioN
Powerful rotary hammer drill with SdS Max chuck. Two functions, hammer and rotary hammer. Anti-vibration shock absorbers built in to body.
Step less variable speed control trigger. Safety clutch system. led mains power indicator. easy access grease plug for gear maintenance.
Supplied with in storage case with 18mm masonry drill bit, pin chisel, PVC dust cap and depth gauge. Fitted with 360° auxiliary handle.
3. SPeCifiCatioN
model No: ........................................................... SDSmaX40
Chuck Type: ............................................................ SdS Max
Concrete drilling diameter: .......................................... 40mm
Impact energy: ................................................................. 12J
Impact Rate: ............................................................ 3780bpm
no load Speed: ......................................................0-480rpm
noise power ...............................................................106dBA
noise pressure .............................................................95dBA
Vibration ................................................................. 16.45m/s²
Uncertainty ................................................................. 1.5m/s²
4. featuReS
5. oPeRatioN
5.1.
Check the work area for concealed cables and utility pipes.
5.2.
fit aDDitioNal HaNDle, fig.2
5.2.1.
For safety reasons only use the hammer drill with the additional handle.
5.2.2.
The additional handle (6) enables you to achieve better stability whilst using the hammer drill. The machine must not be used
without the additional handle (6) for safety reasons.
5.2.3.
The additional handle (6) is secured to the hammer drill by a clamp. Turning the handle anticlockwise (looking from the handle) will
release the clamp. Turning the handle clockwise will tighten the clamp.
5.2.4.
First release the additional handle clamp. You can then swing the additional handle (6) into the most comfortable working position
for you. now turn the additional handle in the opposite direction again until the additional handle is secure.
© Jack Sealey limited
1.
2.
fig.1
3.
4.
5.
6.
Original Language Version
dust guard
locking sleeve
Rotary switch for rotation stop/hammer stop
On/Off switch
Handle
Additional handle
SDSMAX40 Issue 1 09/09/19
fig.2
Advertisement
