Feurst Turnkey Series Installation And Removal

Assembly instructions
Equipment : The use of the TK13OD tool is
recommended for turnkey teeth assembly/
disassembly.
Always work safely and wear your safety
equipment (hard hat, steel-toed shoes,
gloves, safety glasses).
Keep bystanders away.
Tooth assembly : Firstly install Turnkey®
wear cap on top of the adapter, then install
the tooth on the adapter.
Clac !!
Correct positioning : Pin is correctly
"clac"
installed when you hear a sound
informing of correct pin lockings.
TURNKEY® pins Installation and Removal,
TURNKEY® Range.
Cleaning : Tilt the bucket 30° upwards.
Before inserting turnkey sleeve in its hou-
sing, we recommend to clean the adapter
sleeve housing as well as the adapter nose
to make sure the sleeve will be correctly
positioned into the sleeve housing.
4
Pin insertion : Once the teeth is correctly
installed on the adapter, insert TK13CL® pin
into the key hole while respecting the inser-
tion direction (pin head down), then push it
to the end.
The pin as well as the sleeve have mechani-
cal codings to avoid any incorrect insertion.
8
Correct locking : After the "clac" sound,
the pin will be locked as shown.
The pin rotation is fully completed, the pin
cannot be turned any further.
Boulevard de la Boissonnette - 42110 - FEURS
1
30°
Sleeve insertion : Manually insert the
sleeve. You will notice on the sleeve & the
adapters some notches to make sure to
respect the sleeve insertion direction.
We now advise you to grab TK13OD® tool to
proceed for installation.
5
Pin insertion (2): Before pin clamping, the
"head down"
pin should be in
9
Correct locking (2): Once the pin has been
correctly installed and locked, the pin
"head on top"
should be in
FEURST
Tel : 04.77.27.40.63
Fax : 04.77.27.09.84
2
Sleeve insertion (2): We advise to use the
TK13OD® to fully push the sleeve into its
housing.
6
Pin clamping : Once the pin has been
correctly installed, take TK13 OD® tool
position.
to screw the pin. Make sure to push the
pin into the sleeve with the tool before
screwing and then make a 180°
counterclockwise pin turn.
10
Protective caps installation
sides, insert the protective caps to avoid
fines to fill up the pin hole. (Left cap is
position.
TK13CPL and right cap is TK13CPR). These
protective caps will allow you to decrease
teeth replacement time.
3
7
11
: On both teeth