Table of Contents
Advertisement
Quick Links
Quick Start Guide
This document provides a brief overview and introduction on how to install and set-up the
Sparrowhawk FX Video development board and run the pre-installed IQ-Video Demo.
Please refer to the Sparrowhawk FX Page on the Mikroprojekt website at http://www.
mikroprojekt.hr/en/development-systems/sparrowhawk-fx for further details, documentation,
demo designs and other collateral included with the board.
Handling and precautions
Although protected with onboard devices, the Sparrowhawk FX board is an electrostatic
sensitive device. To prolong the life of your development system, the following precautions
apply:
•
Use anti-static precautions such as operating on an anti-static mat or using an anti-static
wristband
•
Touch and hold the board at the following points: The power switch, push buttons, or DVI
Connectors
•
Store the board in the provided anti-static packaging
2. Connect the
power supply
Connect the power
supply to the Power
connector as shown
in the image.
1. Check box contents
The package should contain:
•
The Sparrowhawk FX
Development board
•
AC/DC Power supply
•
This document
Advertisement
Table of Contents
Related Manuals for Mikroprojekt Sparrowhawk FX
Summary of Contents for Mikroprojekt Sparrowhawk FX
- Page 1 This document provides a brief overview and introduction on how to install and set-up the Sparrowhawk FX Video development board and run the pre-installed IQ-Video Demo. Please refer to the Sparrowhawk FX Page on the Mikroprojekt website at http://www. mikroprojekt.hr/en/development-systems/sparrowhawk-fx for further details, documentation, demo designs and other collateral included with the board.
- Page 2 3. Connect the monitor Connect a monitor to the “DVI Output 1” Port with a DVI or a DVI-to-HDMI cable. A 1920 x 1080p monitor is strongly recommended for optimum demo performance. 4. Power up the board Set the power switch to the “ON” Position. The Onboard LEDs should flash, then start powering up in sequence.
- Page 3 7. Check demo control The IQ-Video demo is controlled by the onboard buttons, SW2-SW5. Press SW2 once. The Mikroprojekt logo and a scrolling banner will appear over the test image. 8. Connect video sources Connect video sources to DVI inputs 0 and 1.
- Page 4 Exclusive Alliance of Design 10040 Zagreb Engineering Resources. Croatia For more information, visit: tel/fax: +385 1 2455 659 http://www.latticesemi.com. mail: contact@mikroprojekt.hr http://www.mikroprojekt.hr Copyright ©2012 Mikroprojekt. All brand names or product names are trademarks or registered trademarks of their respective holders. QS-SHFX-EN May 2012.
Need help?
Do you have a question about the Sparrowhawk FX and is the answer not in the manual?
Questions and answers