Advertisement
Steam Ironing
To successfully steam iron the Water Reservoir
be at least ¼ full and the Temperature Control Dial
must be set to ● ● or higher.
1. Set the Steam Control
steam.
2. The Iron is ready to steam iron when the
Thermostat Light
Spray Function
Before using the Spray Function test for water spotting
on a hidden part of the fabric. The Water Reservoir
must be at least ¼ full.
1. Lift the Iron off the fabric, aim the Spray Nozzle
at the fabric.
2. Press the
Spray Button
NOTE: It may be necessary to press the
Button
several times to start the function.
Steam Shot Function
To successfully use the Steam Shot Function the
Water Reservoir
must be at least ¼ full and the
Temperature Control Dial
higher.
1. Lift the Iron off the fabric.
2. Press the
Steam Shot Button
Let the steam recharge for 4 seconds between each
use.
NOTE: It may be necessary to press the
Button
several times to start the function. For the
best Steam Shot quality do not use the function more
than three successive times before allowing the Iron to
return to temperature.
Vertical Steaming Function
To successfully use the Vertical Steaming Function the
Temperature Control Dial
MAX and the Steam Control
1. Hold the Iron close to (but not touching) the fabric.
2. Press the
button.
Let the steam recharge for 4 seconds between each
use.
NOTE: Do not use the function more than three
successive times before allowing the Iron to return to
temperature.
to the desired level of
extinguishes.
.
Spray
must be set to ● ● or
.
Steam Shot
must be set to ● ● ●
to
.
After Use/Storage
1. Set the Temperature Control
must
Dial
Steam Control
2. Unplug the Iron and allow to sit
on its Heel Rest
3. Once cool, open the Water Inlet
Cover
down over a sink and drain the
Water Reservoir
4. Close the Water Inlet Cover
and wipe away any spillage.
To avoid corrosion, store the Iron on
its Heel Rest
Self Clean Function
Use the Self Clean function at least
monthly to reduce scale build-up.
1. Fill the Water Reservoir
Max mark.
2. To successfully use the Self
Clean function the Temperature
Control Dial
● ● ● MAX and the Steam
Control
3. Sit the Iron on its Heel Rest
, plug in and wait for the
Thermostat Light
extinguish.
4. Hold the Iron over a heat
resistant basin or bowl, with the
Soleplate
5. Press and hold the Self Clean
Button
the Iron over the basin or bowl.
6. Hot water and steam will flush
any scale and dust through the
Soleplate
or bowl.
CAUTION KEEP CLEAR OF HOT
WATER AND STEAM
7. When the Water Reservoir
empty, release the Self Clean
Button
8. Follow the After Use/Storage
instructions.
Steam Iron
to ● and the
to
.
until it cools.
, turn the Iron upside
.
.
to the
must be set to
to
.
to
down.
while gently moving
and into the basin
.
is
Advertisement
