Subscribe to Our Youtube Channel
Related Manuals for Realfiction Dreamoc XL2
Summary of Contents for Realfiction Dreamoc XL2
- Page 2 Content Package contents How to assemble the stand Troubleshooting...
- Page 3 When receiving the Dreamoc Stand Please be careful when unwrapping the Dreamoc Stand. The surface is hard coated, but will still need to be handled with care. Package contents...
- Page 4 How to assemble the stand NB: To avoid damage or scratches, it is a good idea to assemble the stand on top of a carpet or the open packaging. Start by clicking the one side-panel together with the one edge-panel as showed below.
- Page 5 The stand is now assembled, but should be stabilized by adding the brace hold together by the bolts. Start by adding the screws, that should hold the structure together. In the corners like showed below. Use two screws on all four corners.
- Page 6 Now the brace should be attached. Unfold it, and stretch it across the stand, making the wholes fit with the bolts, sticking down from the edge- panels. NB: Two persons are recommended for this job. Once the brace is in place, grab a wing screw and screw it onto the bolts sticking down as showed below.
- Page 7 The stand is then assembled and should look like this. Now turn the stand over 180 degrees. & To protect the edges and to avoid the Dreamoc from sliding, you can apply the rubber strips to the edges on the top of the stand. Start in the corners, as shown above and use both hands to apply the strips on all four sides.
- Page 8 Now the stand is ready to use together with the Dreamoc XL2. Gently lift the Dreamoc XL2 to the top of the stand, making sure the Dreamocʼs feetʼs fits into the holes on the top of the stand. Now youʼre ready...
- Page 9 Troubleshooting Problem Solution (General) The stand is - Make sure that the screws, holding the stand together, unbalanced is tightened enough. - Loosen the screws and cross target the stand as shown below: - When the diagonals are precisely equal in length, fasten the screws in the sides again.
Need help?
Do you have a question about the Dreamoc XL2 and is the answer not in the manual?
Questions and answers