Advertisement
WATER DISPENSER,
The PSH_23 water dispenser has been designed & manufactured from quality materials. If these instructions
are followed, the unit will give reliable efficient service. If you need any further information or advice, please
contact:
The installer must pass these instructions & the installation & commissioning instructions to the customer.
a. The unit is switched ON & OFF by the main isolation switch provided by the installer & positioned in the
maintenance duct adjacent to the electronic control box. If a fault occurs with the unit then it must be
switched OFF until the fault is repaired by a qualified engineer.
Warning! Unqualified personnel must not remove the cover of the electronic control box due to the
b. To use the water dispenser, pressing the push switch located above the basin opening activates the
water. The switch does not have any moving parts and is activated by lightly pressing on the centre of the
button with your finger tip. Once the cycle is activated it will run for ten seconds & stop.
c. If the time cycle of 10 seconds requires to be adjusted then this can be done by a qualified engineer who
shall need to gain access to the electronic control box. Further assistance with this can be supplied by
contacting Wallgate at the telephone number stated above.
d. The electronic control unit only activates the water ON or OFF & does not have any affect with the water
temperature which would be controlled before this product as a part of the plumbing installation.
a. Wallgate operates a comprehensive service package, details of which can be obtained from our "After
Sales Service Department". A full spare parts facility is also available.
b. General wear will mainly affect the components in contact with the water. If the unit is installed in a hard
water area then lime scale removers should be used on the basin and water nozzle components. The
water nozzle can be dismantled using a special key so that the inserts can be either replaced or
immersed for cleaning. Details of the key & components are detailed in the spares list table below.
c. Any service or repair work must be carried out by a qualified engineer, which during the warranty period
must be a Wallgate engineer or appointed service agent. Contact Wallgate to report any warranty
breakdowns.
Part No:
Description.
ES6802_2m
PUSH SWITCH.
Crow Lane, Wilton, Salisbury, Wiltshire, SP2 OHB.
User & Maintenance Instructions.
Wallgate Ltd, Crow Lane, Wilton,
Salisbury, Wiltshire, SP2 OHB.
Telephone: (01722) 744594 - Fax: (01722) 742933.
1. OPERATING THE UNIT.
risk of electric shock.
2. MAINTENANCE.
Contact our customer services department
for service & spares requirements:
Tele: (01722) 744594
Wallgate Ltd.
Model PSH_23.
Part No:
Description.
Fax: (01722) 742933.
Issue 1.
Advertisement
