Rhino-Rack Sunseeker II Fitting Instructions

Rhino-Rack Sunseeker II Base Tent Stand Alone Fitment (32124)
Item Component Name
1 Carry Bag
2 Guy Rope
3 Metal Peg
4 Telescopic Support Pole
5 Instructions
Tools Required:
Rubber Mallet or Hammer
1
Fix the four corners of the Base Tent to the ground using the metal
pegs.
2
Insert the Upper Support Poles into
the material tubes on the roof of the
tent. Note: Support Poles included in
Base Tent Kit.
3
Insert the Telescopic Poles into the
ring fixture points on the front side of
the tent.
3 Pike Street, Rydalmere,
NSW 2116, Australia.
(Ph) (02) 9638 4744
(Fax) (02) 9638 4822
Qty Part No.
1 -
8 C910
2 C909
-
4
1 R662
Instructions
1: Slide the Base Tent roof
supports through the
material tubes. Use care
when doing so as to not
damage the tent.
Document No: R662
Prepared By: Kayle Everett
Authorised By: Chris Murty
1. 2.
Pole spike
into this
eyelet.
Hammer the
pegs firmly into
the ground.
2: Slide the Base Tent roof
supports into the plastic
housings on each corner of
the roof.
3.
4.
Issue No: 01
Issue Date: 27/01/2015