Pei tel PTCarPhone 6 Installation Instructions Manual page 11

Setup
Inserting the SIM card
A valid and activated SIM card is required to ope-
rate the device. This is available from your mobile
phone provider. It saves all the important data of
your connection.
To open the SIM card holder, push the round
button in the housing with a pointed object. Place
the SIM card in the holder and push it back in the
electronics box.
NOTE:
z Insert the SIM card only if the device and the
vehicle ignition are turned off.
Make sure to insert the SIM card holder in
z
the correct position. Closing does not require
strong force.
z If a piece of plastic remains on the edge of
the SIM card when taking it out, it is neces-
sary to remove this before inserting the SIM
card.
Inputting PIN
If a PIN is required it will be requested with an
appropriate message when starting the device.
Enter the PIN using the input keys
confirm with the OK function key. Corrections can
be made with the Delete function key.
PIN input is shown with asterisks so that it cannot
be seen. The subsequent
registration in the network can take a few
seconds.
After entering an incorrect PIN three times the
SIM card is blocked. The PUK is requested for
unblocking.
www.peitel.de
Setting the delay time
After turning off the ignition the device runs for
the set delay time and then turns off.
Use the following menu path to set the delay
time:
System > Configuration > device code input >
Delay timer
The device code at delivery is: 0000
Software update
Software updates for the handset and PTCar-
Phone are done via the Internet access of the
mobile network. Therefore, Internet access must
be set up beforehand.
System > Device info > Update > device code input
> Update process
The device code at delivery is: 0000
Turning on virtual ignition
In modern vehicles without ignition wiring it is
recommended to activate the Virtual ignition
function.
System > Configuration > device code input >
Virtual ignition
The device code at delivery is: 0000
WiFi Activation
System > Configuration > device code input >
and
WiFi
The device code at delivery is: 0000
ENGLISH
11