Assembly Sequence - Pei tel PTCarPhone 6 Installation Instructions Manual

Assembly

Assembly Sequence

1. Become familiar with the connections. Dis-
connect the negative terminal of the vehicle
battery while following the safety instructions
of the vehicle manufacturer.
2. Select the installation locations for the
electronics box, handset, loudspeaker, hands-
free microphone and the antenna(s), paying
attention to the cable lengths and installation
instructions and mount the components.
When drilling holes make sure that the
vehicle is not damaged. Use cable bushings on
sharp-edged holes.
3. Install the included hands-free microphone.
Make sure that air fl ow from the vents is not
in the direction of the microphone. Also refer
to "Mounting locations for the microphone"
below.
Then install the loudspeaker (a good location
is the passenger footwell). During installation
of the microphone and loudspeaker make sure
of suffi ciently large spatial separation, to avoid
acoustic feedback.
4. Connect the power supply cable (red) on the
permanent positive and the ignition input (yel-
low/black) to the ignition *, if present. Do not
connect the ignition input (yellow/black) onto
permanent positive, since this limits the scope
of function of the device.
Connection of the ground cable is done directly
to the vehicle battery, the central ground point
(ground block) or a part of the vehicle body.
* For vehicles without ignition wiring it is
recommended at the end of the installation to
activate the "Virtual ignition" function.
5. Connect the violet cable with the mute input of
the car radio. This ensures automatic radio mute
switching for incoming and outgoing calls.
6. Insulate unused cables so no short circuits can
occur.
7. Connect the individual components of the
device with each other using the plug and screw
connections (see connection diagram).
8. Check the total installation and insert a valid
SIM card. Connect the vehicle battery.
www.peitel.de
9. For vehicles with ignition wiring: Turn on the
ignition. The device now turns on and requests
the input of the PIN (if this was not deactivated
on the SIM card).
For vehicles without ignition wiring: Turn the
device on with the end key
handset.
10. Enter the PIN. The telephone is now registered
in the network.
11. Make a call in order to check the basic functions.
12. Check whether there is new software available
and if necessary perform a software update.
Downloading of software updates can incur
costs, depending on the mobile phone contract.
13. If desired, make personal settings on the device
(see chapter "Setting up the PTCarPhone" on the
back) and fi nish the installation.
Mounting location for the microphone
A Optimum position
Alternative position
B
C Limited suitability
B
Microphone alignment
1
1
Maximum sensitivity
2
Adhesive tape for smooth (fl at) surfaces
ENGLISH
/ on the
A
C
2
10