Get Started; Charge The Battery; Pair The Headphones With Your Mobile Phone - Philips On Ear 4000 Series User Manual

3 Get started

Charge the battery

Note
 Before you use your headset for the first time, place
the headsets in the charging case and charge the
battery for 3 hours for optimum battery capacity and
lifetime.
 Use only the original USB charging cable to avoid
any damage.
 Finish your call before charging the headset, as
connecting the headset for charging will power the
headset off.
Connect the supplied USB charging cable to:
• The Type - C USB charging slot on the
headphones and;
• The charger/USB port of a computer.
LED turns white during charging and
turns off when the headphones in
fully charged.
Tip
 Normally, a full charge takes 2 hours.
Pair the headphones with
your mobile phone
Before you use the headphones with your
mobile phone for the first time, pair it with a
mobile phone. A successful pairing establishes
a unique encrypted link between the
headphones and mobile phone. The
headphones store the last 8 devices in the
memory. If you try to pair more than 8 devices,
the earliest paired device is replaced by the
new one.
Make sure that the headphones are fully
charged and turned off.
Press and hold
blue and white LED flashes alternately.
The headphone remain in
pairing mode for 5 minutes.
Make sure that the mobile phone is
turned on and its Bluetooth feature is
activated.
Pair the headphones with the mobile
phone. For detailed information, refer to
the user manual of your mobile phone.
The following example shows you how to pair
the headphones with your mobile phone.
Activate the Bluetooth feature of your
mobile phone, select Philips TAH4205
Philips TAH4205
for 6 seconds until the