Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Summary of Contents for AFX EVAP
- Page 1 OWNER’S OWNER’S MANUAL MANUAL EVAP COMMERCIAL DEHUMIDIFIER WARNING: To reduce the risk of injury, the user must read and understand the Owner’s Manual before using this product. Save these instructions for future reference. www.afxpower.com /// 877-881-3699 /// info@afxpower.com...
-
Page 2: Table Of Contents
CONTENTS + SPECS SPECIFICATIONS EVAP Model Water Removal AHAM (86F 80%RH) (pints/day) Water Removal AHAM (80.6F 60%RH) (pints/day) Refrigerant R410a Refrigerant Volume (g) CONTENTS High Side Pressure (psig) Specifications ......2 Low Side Pressure (psig) Safety Instructions ...... 3 Operating Range (°F) 33-100 Description ......... -
Page 3: Safety Instructions
• If the appliance is damaged or it malfunctions, do not continue to use it. Unplug the product from the electrical outlet. Refer to troubleshooting guide or contact AFX POWER. • Do not stack this appliance to more than three units. -
Page 4: Description
DESCRIPTION DESCRIPTION The EVAP dehumidifier utilizes its integral humidistat to monitor the conditioned space. Once conditions are outside the desired setpoint, the compressor energizes and air is drawn across the evaporator coil. The evaporator coil is cooler than the dew point of the air so the water vapor will turn into liquid condensation. -
Page 5: Operation
• Air Circulation: It’s suggested to have a constant efficient air circulation inside the area that you are going to work in, for example, setting up a circulation with AFX Power Air Mover combinations. • Environment Temperature/Humidity: The dehumidifier is designed to work in an environment with a temperature of 33°F to 100°F (1°C to 37°C) and relative humidity level of 20% and higher. -
Page 6: Control Panel
CONTROL PANEL CONTROL PANEL BUTTONS 1. POWER 4. LED Display 7. Purging Indicator 2. UP 5. PURGE 8. Defrosting Indicator 3. DOWN 6. TIME 9. Running Indicator POWER If the unit is plugged in but not in operation, the LED Display will display nothing. Press the POWER key to turn the unit on. -
Page 7: Humidity Control
CONTROL PANEL + MAINTENANCE HUMIDITY CONTROL The desired humidity could be changed by pressing UP or DOWN keys to set or adjust humidity by 1% increments in the range between 26% and 90%. When the environmental humidity is below 26% “CO” will be displayed. -
Page 8: Filter Maintenance
MAINTENANCE FILTER MAINTENANCE 1. Unplug the unit. 2. Slide the filter from the grille. 3. Clean and wash the filters with warm water (no soap or cleaners). Gently shake the filter dry, then reinsert it or store in dry and cool area in a sealed container. 4. - Page 9 TROUBLESHOOTING TROUBLESHOOTING PROBLEM POSSIBLE CAUSE SOLUTION Dehumidifier does No electricity. Check for power supply. not start. The power cord is not Remove and reconnect the power cord. properly plugged in. Dehumidifier runs The dehumidification system Wait for 3 minutes (180 seconds) until the but humidity level is within startup process.
- Page 10 The drain hose is blocked. Remove blockage. Turn power back on. If any of the above solutions do not resolve the problem or issue, please contact AFX POWER at 1-877- 881-3699 to determine next steps.
-
Page 11: Limited Warranty
2. Call AFX POWER U.S. Customer Service Department at 1-877-881-3699. Please also have your original proof of purchase ready when you contact AFX POWER. The proof of purchase could be in the form of the original receipt from the retailer where the product was purchased.