Synchronization & Resetting Base's Electronics - Comfort-n-Motion S31 Owner's Manual

Page 5
Step 6 - Twin King Base - Remote Synchronization
Use if you are setting up two (2) twin bases to use with One (1) king size mattress, if not then skip this step.
SYNC CABLE
Base Assembly
Using one king mattress with two twin XL bases requires
synchronization of the two twin control boxes, and allows a
single remote to control both units together. This is achieved
by connecting the SYNC CABLE to each of the control boxes,
one located on the underside of each twin base, activating the
sychronization.
Locate the SYNC CABLE in the accessories box.
The Sync Cable is 80" long and is designed with the length
required to connect the (2) control boxes.
First insert the cable into the "Sync Cable" inlet on each of the
bed's control box. After the beds are connected turn them over
gently using at least two people. Rotate the beds towards each
other when flipping due to the sync cable connection. Your two
beds should now be ready to work with either remote control.
Reset your Adjustable Bed to Original Factory Settings
If you ever need or want to reset your controls to the
original factory settings for any reason. Match remote #1 with
control box #1, hold all three buttons indicated below until you
hear the beep or flashing orange LED light. Do the same with
remote #2 and control box #2.
Remote #1
An example would be if you previously
programmed your two control boxes to
work together but now you want them to
operate independently.
Control Box Base #1