Base Assembly - Comfort-n-Motion S31 Owner's Manual

Base Assembly

Step 2
Screw in the provided legs (4) in each corner of the base rota-
ting clockwise until tight. DO NOT OVERTIGHTEN THE
LEGS.
Step 3
Untie and remove the twist ties
from the cables and release the
DC cord.
NOTE:
THESE BACKUP BATTERIES WILL ALLOW THE BED TO BE LOWERED IF A POWER OUTAGE
OCCURS. IT IS RECOMMENDED NOT TO DO ANYTHING EXCEPT TO LOWER THE BED AS THE BATTERY
BACKUP WILL NOT ELEVATE THE BED SECTIONS.
*It is recommended to replace the two 9 volt batteries every 12 months.
Step 4
Plug the two 9 volt batteries
(included) in the compartment of
the Power Supply and insert the
cover to close.*
Step 1
It is highly recommended to use two people
for the installation of this product. Before
assembly, place the unit in the appropriate
final position to make the assembly process
easier. The unit should be placed top side
down on the floor according to the box
instructions. Remove the 2 boxes included and
untie the mattress retainer.
Step 5
Insert the AC cord into the Power
Supply and lock it using the clip.
DO NOT PLUG BASE INTO
THE POWER OUTLET YET.
Page 4