Connections - SAFEMATIC MLP Series Manual

Note

4.4 Connections

Input
•
pressure switch, 2 pcs, closing contact
or pressure transmitter, 2 pcs, 4–20 mA / 0–250 bar, 2-wire type
•
interlocking, lubrication points in operation when external interlocking switch is open
Output
•
lubricant, 2 pcs, female thread R ¼"
•
alarm, potential-free contact open in alarm mode, load 115V / 1A max.
Cable channels in the intermediate plate
•
PG 13,5 cable gland, 2 pcs, for 6-12 mm cable diameters
•
PG 11 cable gland, 2 pcs, for 4-10 mm cable diameters
HMLU2CEN.doc
This equipment has been tested and found to comply with the limits for
Class B digital device, pursuant to Part 15 of the FCC Rules. These limits
are designed to provide reasonable protection against harmful interference
in residential installation. This equipment generates, uses and can radiate
radio frequency energy and, if not installed and used in accordance with the
instruction manual, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation. If this device does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct
the interference by one or more of the following measures:
- reorient or relocate the receiving antenna
- increase the separation between the equipment and receiver
- connect the equipment into an outlet on a circuit different from that to
which the receiver is connected
- Consult the dealer or an experienced radio/TV technician for help.
MULTILUBE
MLP
4 (5)
21.03.2006 Rev. 2C