Related Manuals for PlasmaPart 200A MMA CI
Summary of Contents for PlasmaPart 200A MMA CI
- Page 1 Operation & Safety 200CI manual Inverter DC Arc 15-200Amps DC - Single Phase - 240V Welder...
- Page 2 …………………………………….. Invoice Number …………………………………….. This manual has been written to instruct you in the correct and safe use of your PlasmaPart product please read and fully understand it before use. Your understanding of the product is key to your safety, welding is hazardous, by taking the correct precautions you can minimise the inherent hazards associated with welding.
-
Page 3: Important Safety Information
Important Safety Information The following information is extremely important and must be observed, this section is in addition to specific hazard warnings that are mentioned throughout the manual where appropriate The operation and routine maintenance of welding equipment can be extremely dangerous and hazardous to your health and wellbeing. - Page 4 Hazardous gases & fumes Gases produced during the welding process can be dangerous and may affect your health. Please take precautions to avoid inhaling them Ensure your work area is well ventilated, or that you are wearing sufficient protective equipment to avoid inhaling the fumes ...
- Page 5 Welding Arc Ultraviolet Radiation Welding arc radiation can burn your eyes and skin, without adequate protection your eyes and skin are at risk, if exposed your eyesight can be permanently damaged please ensure you are wearing adequate PPE. The following should be treated as a guide as to the minimum shade numbers to use for eye protection while plasma cutting.
-
Page 6: Declaration Of Conformity
EMC directive and to the national legislation for the enforcement of this directive. PlasmaPart machines are the result of extensive and continuous product development. Our manufacturing process is two-part and once the base units arrive at our facilities they are completed to our specification in the UK. -
Page 7: Statement Of Warranty
In no event shall PlasmaPart be liable or responsible to you or any third party for any personal, mental, physical injury or illness, consequential, direct, indirect, special or contingent damages arising from the use, misuse or failure of the product(s) sold or advice given. - Page 8 Power Source Specifications MMA 200 CI Supply Voltage 1-ph AC 220±15% V Supply Frequency 50~60 Hz Power requirement (at 200A) 4.8 KVA (Max) Rated input current (at 200A) 16 A (Max) No-load voltage 90 V Output current range 20-200 A Output voltage range 15-40 V Duty cycle @ 185 Amps Output...
- Page 9 In this case a 16A 240V plug is pre-wired to your machine, under certain circumstances you may use your PlasmaPart system whilst connected to a 13amp 240V supply, you must however not use the system with a welding amperage of over 100amps whilst connected to a 13amp standard 3 pin plug, any higher than this and the unit will draw more than 13amps input current and the 13amp fuse will fail.
- Page 10 Thank you again for your purchase and we hope your PlasmaPart welding system gives you many trouble free years of operation If you need to get in touch for advice, to purchase spares, for warranty support, service or for any other reason you can contact us here...