Connect And Power Up; Set Up The Unit Name And Ip Address - digico 4RE4 A-CONTROL6 Getting Started Manual

5. Connect and power up

5.1 Set up the unit Name and IP Address

When connecting multiple AC Remote Controllers to the same network, ensure each unit
is set to a unique Name and IP Address beforehand. Alternatively, you can enable DHCP
on the Remote Controllers, provided a DHCP Server is present on the network and the
DHCP range is compatible with the IP Address of the mixing system.
The factory default settings are as follows:
Unit Name
DHCP
IP Address
Subnet Mask
Gateway
There are two ways of editing these settings:
Browser access
Network port of the A-CONTROL6. Set your computer to a
compatible, static IP Address, for example 192.168.1.100 with
Subnet 255.255.255.0. Open a web browser and type the A-
CONTROL6 default IP Address 192.168.1.72 in the URL bar. This
will give access to the unit network settings. Repeat the operation
for each A-CONTROL6 unit.
4REA4 software
Network port. Use the 4REA4 Controller software to edit the A-
CONTROL6 network settings. Once applied, repeat the operation
for each A-CONTROL6 unit.

Refer to the 4REA4 Reference Guide available for download at
http://www.digico.biz
A-Control6 Getting Started Guide
A-CONTROL6
Off
192.168.1.72
255.255.255.0
192.168.1.254
– Connect a PC or Mac computer to the
– Connect the A-CONTROL6 to a 4REA4
for more information.
11 AP11451 Issue 1