Advertisement
C. Route the power supply wire harness down
the LH side of the handle towards the rear
of the engine.
D. Connect the harness to the two bullet
connectors coming from the engine shroud.
• On battery models
A. Locate the open wire harness connector on
the eFlex main wire harness.
B. Connect the LED light wire harness to the
light connector plug on the eFlex main wire
harness.
C. Install the switch connector plug on the eFlex
main wire harness to the On/Off switch.
The remaining wire harness will not be used
for this application.
11. Loosely attach the wire harness to the light bar and
handle with (5) cable ties (Figure 5).
1
1. Cable tie (5)
Note: Before tightening the cable ties, make sure
the LED lights are directed slightly downward
from the expected final position. This can prevent
damaging the harness connectors when/if the lights
are rotated downward.
Important: If the handle is not fully extended
out, make sure there is sufficient slack in the
wire harness (approximately 3 inches) between
the lowest cable tie on the handle and the
connecting points on the engine (gas models
only) and the light bar.
12. Install the console cover to the handle with the (4)
screws previously removed.
13. Tighten the cable ties.
Figure 5
1
G023458
4
Advertisement
