Advertisement
Installation
Electrical connection
Appliances with three‐pole cable are set up for operation with alternating current at
the voltage and frequency indicated on the rating plate. Look at the connection
wiring diagram. The earth conductor is yellow/green.
The connection to the electricity supply must be made by a qualified person and
following the regulations in force.
When the appliance is to be installed above a built‐in oven, the two appliances must
be connected separately, to make it easier to take the appliances out and for
electrical safety.
The supply cable must be so positioned that no point can reach a temperature 50° C
higher than ambient temperature.
Also check that the supply system has an effective earth connection and corresponds
to the standards in force and that the plug (or omnipolar switch) can be reached
easily when the appliance is installed.
The manufacturer refuses all responsibility If the standards in force are not
respected.
TECHNICAL INFORMATION FOR INSTALLATION PERSONNEL
This appliance must be installed only by authorised personnel and in accordance
with the regulations of Electricity authorities. The wall and bench surfaces must be
capable of sustaining temperatures of 75 degrees Celsius. All laminates, fixing
adhesive and surfacing materials should be certified suitable for this temperature.
Refer to figure 6 for required clearances around appliance and for the cutout in the
bench top.
6
Advertisement
