AMPHORA Ready with Wheels Assembly Instructions

Assembly Instructions
AMPHORA Ready with Wheels
Warning
The glazing is very fragile and the edges are prone to
damage during the transport or assembling.
When working with the shaped pieces of the body,
proceed very carefully, do not use excessive force.
If a light damage occurs, you can use the supplied
silicone caulk or any nail-polish with similar colour to
repaint the discrepancy.
Stand with wheels is designed only for short transfers
on flat and hard surface. Always push the oven from
the front side and ensure that rotatable wheels are
always oriented to you. When standing idle, wheels
should be oriented to the front (see image above).
Caution: The material is reinforced by metal needles,
which are sharp and may in some places protrude
from casteble shapes. Therefore please pay attention
when manipulating.
7) 7)
Bolt the holders for accessories
to the opposite side to the side shelf.
1)
+
Bolt the wheels to the stand legs according to the illustration.
Insert spacers between the fixed wheel (P7) and the wheel axis (short spacers).
Put the wheel axis together with a guide tube (long one) through these spacers.
Place washer, spring washer and nut on the axis and tighten it.
4) 4)
Bolt partitions between individual legs
(direct the bends inwards). Tighten
all the already applied bolted joints.
8) 8)
Using a bonding agent, glue the bio-mat (part I1 rear bottom according
to the cutting plan of the bio-mat) to the bottom cutout of the bottom rear
plate, place the plate by this bottom side with the bio-mat to a stand.
2)
Bolt the bottom plate to the stand legs. Do not
tighten the joints. In case the a screw doesn't easily
fit into a hole, make the hole wider with a file. Paint
over the altered surface with a paint for metal.
5) 5)
Insert the front shelf into the grooves and bolt
it on both sides. Do not tighten the joints
too much, movement of the shelf in the grooves
needs to be secured so that it can tilt.
9) 9)
Cut the rubber pad P12 (1 mm thick) according to the size of the front stopper
and glue it to the inner side of the stoppers using the silicone caulk.
Using a bonding agent, glue the bio-mat (part I2 front bottom according
to the cutting plan of the bio-mat) into the bottom cutout of the bottom
front plate, place the plate by this bottom side with the bio-mat to the stand.
3) 3)
Screw stand legs to the top plate.
Do not tighten the joints.
6)
Bolt the batten S8 Bolt the batten S8 for the
side shelf to the stand At side shelf to the stand. Attach the
shelf to the batten by pulling the axis through and securing it on
both sides against slipping out by washers and lock rings. The side to
which the side shelf is to be mounted may be selected as necessary.
10) 10)
Place the inner plate
into the bottom plate cutout.