Toro Groundsmaster 4500-D Operator's Manual page 12

2
Installing the Hood Latch
(CE Machines Only)
Parts needed for this procedure:
1 Hood-latch bracket
2 Rivet
1 Washer
1 Screw (1/4 x 2 inches)
1 Locknut (1/4 inch)
Procedure
1. Unhook the hood latch from the hood-latch
bracket.
2. Remove the 2 rivets securing the hood-latch
bracket to the hood
hood-latch bracket from the hood.
2
1. Hood-latch bracket
3. While aligning the mounting holes, position the
CE lock bracket and the hood-latch bracket onto
the hood (Figure
Note:
The lock bracket must be against the
hood. Do not remove the bolt and nut from the
lock-bracket arm.
(Figure 3). Remove the
1
G012628
Figure 3
2. Rivets
4).
1. CE lock bracket
4. Align the washers with the holes on the inside of
the hood.
5. Rivet the brackets and the washers to the hood
(Figure 4).
6. Hook the latch onto the hood-latch bracket
(Figure 5).
1
1. Hood latch
g012628 7. Screw the bolt into the other arm of the
hood-latch bracket to lock the latch in position
(Figure 6). Tighten the bolt but do not tighten
the nut.
12
1
2
G012629
Figure 4
2. Bolt and nut
G012630
Figure 5
g012629
g012630