Table of Contents
Advertisement
STEP 3: Install 3/8" lag screws to secure rack to wood
support boards.
STEP 5: While person 2 holds the second Off Grid Rack
upright, vertically level, flush against wood support
boards/ground, mark pilot holes on your wood support
boards using a marker/pen/pencil and secure 3/8" lag
screws to to your support boards.
CONCRETE WALL INSTRUCTIONS: In the event you are planning to mount your Off Grid™ rack to a concrete or block wall.
Standard install instruction apply with regard to securing your rack to wood support boards. We recommend using epoxy to
secure your anchors and boards to the concrete wall for added structural stability of your drilling holes. If needed, please
contact us at info@sorinex.com for additional advice.
In no event shall Sorinex Exercise Equipment, Inc. be liable for any direct, indirect, punitive, incidental, special consequential damages, to property or life, whatsoever
arising out of or connected with the use or misuse of our products. Failure to operate this product in a safe and responsible manner could result in injury or damage
to the product or other property. This product is not intended for use by children without direct adult supervision. Do not use with incompatible components or alter
this product in any way outside of the documents provided by Sorinex Exercise Equipment, Inc., these Off Grid Rack step-by-step instructions for safety, operation and
maintenance. It is essential to read and follow all of the instructions and warnings in the user manual, prior to assembly, setup or use, in order to operate the product
correctly and avoid damage or serious injury.
STEP 4: Recommended width between rack uprights is
41". (Optional widths: 41" - 47"). If you plan to use a bolt-
on stall bar, 41" width is required.
STEP 6: Secure your rack to the floor with (2) 1/2"
concrete anchors.
2020 | SORINEX.COM | 2 of 2
Advertisement
Table of Contents
Need help?
Do you have a question about the OFF-GRID RACK and is the answer not in the manual?