Reece MILLI GLANCE Installation Instructions

MILLI

GLANCE MIRROR

SPECIFICATIONS

Recommended use

Features

Electrical

We recommend the use of a soft dry cloth. This product should not be

cleaned with abrasive materials or cleaning agents.

by improper treatment is not covered by the product warranty - refer

to warranty conditions.

Disclaimer: Products in this specification manual must by regulation be installed by licensed and registered

trades people. The manufacturer/distributor reserves the right to vary specifications or delete models from

their range without prior notification. Dimensions are nominal measurements only. Dimensions and set-outs

listed are correct at time of publication however the manufacturer/distributor takes no responsibility for printing

errors.

Tech Page Version 2

Domestic, hotel and commercial.

Infrared on/off sensor

3x magnifying backlit mirror

5mm glass with PVC safety backing

Defogger function

240V AC / 50Hz / 30W / IP44

Damage caused

To see the complete Milli range go to

www.reece.com.au/bathrooms

page 1 of 4

Table of Contents

Do you have a question about the MILLI GLANCE and is the answer not in the manual?

Page 1 1 of 4 MILLI GLANCE MIRROR To see the complete Milli range go to www.reece.com.au/bathrooms SPECIFICATIONS Recommended use Domestic, hotel and commercial. Features Infrared on/off sensor 3x magnifying backlit mirror 5mm glass with PVC safety backing Defogger function Electrical...
Page 2 page 2 of 4 MILLI GLANCE MIRROR WARNING This mirror must be installed by a qualified electrician in accordance with AS/NZS 3000 wiring rules. Switch off the electrical supply at the mains before installation and maintenance. A means of disconnection must be incorporated in the fixed wiring in accordance with the wiring rules.
Page 3 page 3 of 4 MILLI GLANCE MIRROR INSTALLATION INSTRUCTIONS Feed electrical wiring through rear of mirror casing Remove screws from mirror casing as indicated. and fix casing to wall Separate mirror from casing. Complete all required electrical connections and Disconnect internal wiring. reattach mirror to casing Use mirror casing to mark fixing points.
Page 4 page 4 of 4 MILLI GLANCE MIRROR OPERATION Infrared mirror light on /off sensor Moving your hand in proximity of the sensor turns the mirror light on and off. Please note, that the mirror must be installed not less than 70mm from the wall or bathroom furniture column, otherwise the sensor will read the object and will not function properly.