Download
Share
Print this page
  1. Manuals
  2. Brands
  3. Dakota Grills Manuals
  4. Grill
  5. Road Runner
  6. Packing slip & assembly instructions

Dakota Grills Road Runner Packing Slip & Assembly Instructions

Hide thumbs
1
2
3
4
5
6

Advertisement

Quick Links

Download this manual
Dakota Grills,
Dakota Grills,
Road Runner: Packing Slip & Assembly Instructions
Tools Needed
Philips screwdrivers (medium and small)
Note: you may use a Philips bit on an adjustable-torque, variable-speed drill. This will save time, but
extra care is required.
5/16" nut driver (optional)
7/16" wrench
Needle-nose pliers or 5/16" wrench (regular pliers can work)
1/6
LLC
LLC
(605) 847-4713
(605) 847-4713
www.dakotagrills.com
www.dakotagrills.com
FAST.
FAST.
flavorful.
flavorful.
SIMPLE.
SIMPLE.
44136 200th St.
44136 200th St.
Lake Preston, SD 57249
Lake Preston, SD 57249

Advertisement

loading

Related Manuals for Dakota Grills Road Runner

Summary of Contents for Dakota Grills Road Runner

  • Page 1 FAST. flavorful. flavorful. SIMPLE. SIMPLE. Road Runner: Packing Slip & Assembly Instructions Tools Needed Philips screwdrivers (medium and small) Note: you may use a Philips bit on an adjustable-torque, variable-speed drill. This will save time, but extra care is required.

  • Page 2: Packing Slip

    Packing Slip Package A (large) Grill Body and Lid Lid-Lifted Stainless Steel Grate (top) Package B (oblong) Lid Stop Brackets (one each R & L) Lid Handle L (left) Handle R (right) Handle with Controls Hex-Head ¼” Bolts (2 for each handle) Philips #10 Self-Tapping Screws (for Lid Handle &...
  • Page 3 Step – by – Step Instructions 1. Locate all tools & unpack all parts. Find a soft surface to work on to avoid scratching the parts (carpet or towels work well). 2. Connect the L and R Lid Stop Brackets to the back of the Grill Body, as shown at right, using two self- tapping screws each.
  • Page 4 Finger tighten as much as possible, then snug the nuts a bit more with a pair of needle-nose pliers. Caution: do not over tighten! 5. Finally, you can attach the R Handle. This one requires a few more steps, as follows: 6.
  • Page 5 9. Attach wire connector to power-supply circuit board. Make sure the Connector is lined up correctly – it will only go in one way. Push it all the way in – make sure both side-tabs are “clicked” in place. Gently pull on it to verify it is locked, then gently push it back down to ensure a good connection.
  • Page 6 the tubes of the back element. The heat-shields – one in front and one in back – rest in place in the slotted holders. The location and installation of the grates is shown in the manual. Tip: We recommend that you leave the smoker tray out unless you wish to smoke meats.