Advertisement
Quick Links
Dakota Grills,
Dakota Grills,
Metro: Packing Slip & Assembly Instructions
Tools Needed
Philips screwdrivers (small,
medium & large)
Note: you may use a Philips bit on an
adjustable-torque, variable-speed
drill. This will save time, but extra
care is required.
*5/16" nut driver (optional)
*7/16" wrench
Needle-nose pliers or 5/16"
wrench (regular pliers can work)
*May use included "wrench" tool.
1/8
LLC
LLC
(605) 847-4713
(605) 847-4713
www.dakotagrills.com
www.dakotagrills.com
FAST.
FAST.
flavorful.
flavorful.
SIMPLE.
SIMPLE.
44136 200th St.
44136 200th St.
Lake Preston, SD 57249
Lake Preston, SD 57249
Advertisement
Related Manuals for Dakota Grills Metro
Summary of Contents for Dakota Grills Metro
- Page 1 Dakota Grills, FAST. FAST. flavorful. flavorful. SIMPLE. SIMPLE. Metro: Packing Slip & Assembly Instructions Tools Needed Philips screwdrivers (small, medium & large) Note: you may use a Philips bit on an adjustable-torque, variable-speed drill. This will save time, but extra care is required.
-
Page 2: Packing Slip
Packing Slip Package A (large) Grill Body and Lid Package B (oblong) “Wrench” tool Lid Stop Brackets (one each R & L) Lid Handle L (left) Handle R (right) Handle with Controls L (left) Legs, front & back (long, without wheel holes) R (right) Leg Sets including: 2 R (right) Legs, front &... - Page 3 Step – by – Step Instructions 1. Locate all tools & unpack all parts. Be careful when unpacking the large box; the Lid is not attached to the Grill Body. Find a soft surface to work on to avoid scratching the parts (carpet or towels work well).
- Page 4 3. Now it is time to attach the legs. First, attach the bottom of the two Front Legs, as shown below, with a self-tapping screw. You may use the leg as a lever to hold it in place while starting the screw. If this is a struggle, you may use a 1/4” hex-head bolt (use a 7/16”...
- Page 5 6. Align the Lid with the Grill Body and set it in place. It should rest on the silicone- rubber gasket. The angled part of the Lid should be at the front of the Grill Body, hinges in back. 7. Attach the hinges to the Lid and Grill Body, as shown.
- Page 6 10. Attach the L Handle. First, slide the back of the handle into the L Lid-Stop Bracket. Line up the two threaded studs with the slots on the lid-stop bracket and slid the handle back. Attach the front of the handle to the front of the Grill Body using two hex-head bolts, as shown.
- Page 7 13. Next, while holding onto the R Handle, start the two hex-head bolts in front (repeat Step 10). Tip: a second person may be helpful for aligning and holding the handle while you start the two bolts. Tighten with 7/16” wrench. 14.
- Page 8 18. Congratulations! Your grill is assembled. It is almost ready for use. 19.Plug the grill into a GFCI-protected outlet and turn it on. Make sure everything is working correctly. After the grill starts heating, place your hand near the elements (don't touch!) –...