INSTALLATION
10
Bar
Bar
Copper pipe
Clamp handle
Check
1
Compare the flared work with the figure
by.
2
If a flared section is defective, cut it off
and do flaring work again.
Smooth all round
Inside is shiny without scratches
Inclined
Even length
all round
Connecting the Piping
1
Pull the screw cap at the bottom of the in-
door unit
2
Remove the chassis cover from the unit by
loosing 2 screws
Handle
Yoke
Cone
Red arrow mark
= Improper flaring =
Surface
Cracked Uneven
damaged
thickness
Chassis cover
3
Pull back the tubing holder.
4
Remove pipe port cover and positioning
the tubing
Indoor unit back side view
Right
Downwards
* The feature can be changed according to
type of model.
Good case
- Press on the tubing cover and unfold the
tubing to downward slowly. And then bend
to the left side slowly.
Tubing holder
Left
Backwards