Advertisement
Quick Links
Advertisement
Related Manuals for Rasmussen RPK1-N
Summary of Contents for Rasmussen RPK1-N
- Page 1 Report # 10-38 REV: RPK1-04.10 f i r e - p a r t s . c o m...
- Page 2 STEP TWO: Attach Pilot (Figure 4). 1. With the Pilot Thermo-generator beneath the Pilot Support Bracket, insert the 10-32 Bolts through the drilled-holes in Pilot Support Bracket into the threaded holes of the Pilot Thermogenerator Assembly. Tighten with Screw driver. 2.
- Page 3 STEP SIX: Install Heat Shield. Heat Shield Pilot Adjust Screw Place the Heat Shield on the valve with the notched vertical face between the Valve and the Burner Pan. Ensure that the Heat Shield is over the Valve Assembly as shown in Figure 8 Figure 8 WARNING! HEAT SHIELD MUST BE INSTALLED TO PREVENT PREMATURE VALVE FAILURE AND/OR VOIDING OF VALVE MANUFACTURER'S WARRANTY...
- Page 4 OPERATION IMPORTANT! CHIMNEY DAMPER MUST BE WIDE OPEN CAUTION! DAMPER AND GLASS DOORS MUST BE FULLY OPEN BEFORE LIGHTING OR BURNING FOR PROPER VENTILATION AND TO PREVENT HEAT DAMAGE TO VALVE. THE FLUE MUST VENT ALL PRODUCTS OF COMBUSTION. Burner ON or OFF (Switch and Remote Valve): With the Gas Dial (Figure 9) in the "ON"...
- Page 5 3/8 flared x 3/8 MIP Valve Inlet From Thermo- Generator Valve Outlet From Thermostat Pilot or Aux Input Switch or Remote Figure 4 3/8 flared x 3/8 MIP f i r e - p a r t s . c o m...
Need help?
Do you have a question about the RPK1-N and is the answer not in the manual?
Questions and answers