Parts Supplied; Installation Instructions - Thermador DC36TW Installation Manual

Parts Supplied

1 - Hardware bag
• 4 - 5 x 45 mm installation screws
• 4 - 5.4 x 75 mm installation screws
• 11 - 4.2 x 8 mm installation screws
• 4 - 10 x 60 mm drywall anchors
• 2 - 8 x 40 mm anchors
• Torx adapter 20
• 2 - Upper duct cover brackets
• Mounting template

Installation Instructions

On some models, optional duct covers and telescoping
extensions may be used to fill the space between the hood
and ceiling in wall mount installations.
Model
PH36HWS
PH36GWS
PH48HWS
PH48GWS
Duct Cover Extension Installation
IMPORTANT: Secure the Chimney Hood to the wall after
installing the Extension Mounting Bracket, but before
installing the Telescoping Chimney Extension.
NOTE: Carefully remove the protective film from the duct
cover and hood assembly prior to the start of the installa-
tion. Use one hand to maintain the duct cover steady while
the other hand removes the protective film.
Securing the Telescoping Chimney Extension Bracket
1. Ensure that the minimum height of 30" (762 mm) from
the bottom of the hood to the cooking surface will be
maintained.
Page 4
2. Locate two studs at the mounting brackets location.
Duct Cover
DC36TW
DC48TW
3. Mark the range hood vertical centerline. Make sure the
4. Locate the mounting template in an 90° angle against
5. Make the pilot holes depending on your duct cover
A
Max. 54"
(1372 mm)
Min. 30 7 / "
8
(785 mm)
Min. only lower
duct cover
24" (610 mm)
Model
36" 12" (305 mm)
48" 12" (305 mm)
line run through the very top of the ceiling.
the recently made centerline.
width.
B
24"
(610 mm)
30
(785 mm)
(457 mm)
A B
35 ⁄ " (912 mm)
15
16
47 ⁄ " (1212 mm)
7
8
7 / "
8
18"