Advertisement
If mating wall receptacle is not available or if you are not
sure if the wall receptacle is properly grounded and polar-
ized, have it checked by a qualified electrician. It is the
responsibility and obligation of the customer to have a prop-
erly grounded and correctly polarized 3-prong wall recep-
tacle installed by a qualified electrician. See Figure 1.
Consult a qualified electrician if the grounding instructions
are not completely understood or if doubt exists as to whether
the appliance is properly grounded. See Figure 2 for loca-
tion of electrical outlet inside the opening at the rear.
C. INSTALLATION PROCEDURE
CABINET OPENING
MODEL
DMW13B
1. See Figure 3. All corners should be square. The floor of
the microwave must be level and capable of supporting
100 pounds.
Figure 3
1.
Set Size
2.
Opening Size
3.
Cabinet Size
(Dash Line)
WOOD CABINET
2. Mount the trim frame on the outer case using three 12mm
screws supplied with microwave (two #8 screws not sup-
plied, can be added if desired). Then mount the duct on
the outer case using two 8mm screws (not supplied).
(See Figure 4)
3. Put the microwave oven into the cabinet.
4. Screw the upper and lower trim onto the cabinet using
four screws (not supplied). (See Figure 5)
Note: No screws supplied to install duct.
DIMENSIONS
22.13" wide x 14.53" high
W
x
H
x
D
21.97"
12.56"
16.77"
22.13"
14.53"
22.13"
14.53"
16.02"
22.13
SHOULD BE SOLID BOTTOM
Figure 2
Figure 4
These screws are removed from bottom
of microwave and used to secure frame to
microwave
These screws are removed from bottom
of microwave and used to secure frame to
microwave
Figure 5
2
Duct
#8 Screw
(Optional)
#8 Screw
Lower Trim
(Optional)
Advertisement
