Table of Contents
Advertisement
Installation and connection
en
For the after-sales service
Caution!
The appliance must be connected in accordance
■
with the data on the rating plate.
Only connect the appliance to an electrical
■
connection that meets the applicable provisions. The
socket must be easily accessible so that you can
disconnect the appliance from the electricity supply
if necessary.
Please ensure the availability of a multi-pin
■
disconnecting system.
Never use extension cables or multiple plugs.
■
For safety reasons, this appliance must only be
■
connected to an earthed connection. If the safety
earth terminal does not comply with regulations,
safety against electrical hazards is not guaranteed.
You must use a H 05 W-F type cable or equivalent
■
for the appliance connection.
Horizontal alignment
Always place the appliance directly on the kitchen floor.
The appliance is equipped with height-adjustable feet.
You can raise the appliance approximately 15 mm by
adjusting the feet.
You can adjust the feet, using a spanner, to ensure that
the appliance is horizontal.
Adjacent units
Any adjacent units must not be made of flammable
materials. The fronts of any adjacent units must be heat-
resistant up to at least 90 °C.
Wall fixing
To prevent the cooker from tipping over, you must fix it
to the wall using the enclosed bracket. Please observe
the installation instructions for fixing the oven to the
wall.
Setting up the appliance
The appliance must be set up directly on the kitchen
■
floor and in line with the specified dimensions. The
appliance must not be set up on any other object.
10
The distance between the top edge of the oven and
■
the bottom edge of the extractor hood must meet the
requirements of the extractor hood manufacturer.
Ensure that the appliance is not moved again after
■
set up. The distance from the high output burner or
wok burner to the fronts of the adjacent units or the
wall must be at least 50 mm.
:
Warning – Risk of gas leak!
The appliance must not be moved once it has been
installed.
If you do move the appliance once it has been installed,
check that the connection is leak-tight.
Measures to be noted during transport
Secure all mobile parts in and on the appliance using
an adhesive tape that can be removed without leaving
any traces. Push all accessories (e.g. baking tray) into
the corresponding slots with cardboard at the edges, in
order to avoid damaging the appliance. Place
cardboard or similar between the front and rear side to
prevent knocks against the inside of the glass door.
Secure the door and, if available, the top cover to the
appliance sides using adhesive tape.
Keep the original appliance packaging. Only transport
the appliance in the original packaging. Observe the
transport arrows on the packaging.
If the original packaging is no longer available
pack the appliance in protective packaging to
guarantee sufficient protection against any transport
damage.
Transport the appliance in an upright position. Do not
hold the appliance by the door handle or the
connections on the rear, as these could be damaged.
Do not place any heavy objects on the appliance.
Advertisement
Table of Contents
