Related Manuals for Alcoa Alumax Bath Enclosures STIKSTALL 795 Series
Summary of Contents for Alcoa Alumax Bath Enclosures STIKSTALL 795 Series
- Page 1 INSTALLATION INSTRUCTIONS 795 SERIES STIKSTALL SHOWER ENCLOSURE Copyright © Alumax Bath Enclosures 1997. All rights reserved. EPH-N00-06020 1-26-00...
-
Page 2: Limited Warranty And Remedy
LIMITED WARRANTY AND REMEDY Alumax Bath Enclosures warrants to its dealers, customers, and all subsequent purchasers and users, that the products supplied by it shall be free from material defects in material and workmanship for a period of one (1) year after shipment, provided they are installed and maintained according to Alumax Bath Enclosures' recommended practices and installation instructions. - Page 3 Page 3 of 10 EPH-N00-06020 1-26-00...
- Page 4 The Alumax StikStall framework has been designed to work with a variety of different door types. To ensure correct installation, this 795 Instruction Sheet is designed to be used by itself with a 790 Framed Pivot Door or with an instruction supplement packed with a 390 Frameless Pivot Door, a 790i Intre-Hinge Door or a 1090 Heavy Frameless Pivot Door.
- Page 5 - ALL DOORS Place the two wall jambs [B] into the ends of the curb [A]. Masking tape may be used to hold the curb in place during this operation. Plumb both jambs and mark the hole locations on the walls.
- Page 6 - ALL DOORS Measure the wall-to-wall opening at the top of the wall jambs [B] and cut the header [H] to fit the exact opening. Using a 3/16" drill bit, drill the interior face of the header on both ends as shown. - ALL DOORS Press the header [H] over the wall jambs [B] and the two 180°...
- Page 7 - 790 DOORS ONLY Snap the fillers [P] into the curb [A] and header [H] between the door jambs with the raised lip to the exterior and the pivot holes toward the pivot jamb. Center the curb filler in the curb between the pivot and strike jamb (use masking tape to hold in position).
- Page 8 - 790 DOORS ONLY Insert the two nylon pivot bushings [Y] into the pivot holes in the head and curb fillers [P]. Lift the door panel [L] and insert the top pivot pin into the pivot bushing in the header filler. Hold the door vertical and insert the bottom pivot pin into the pivot bushing in the curb filler.
- Page 9 - 790 DOORS ONLY Attach the interior door handle [BB] and the exterior door handle [CC] to the door panel [L] with two #6-32 x 1 1/4" round head screws [DD]. Close the door and check the clearance with the strike jamb [ N].
- Page 10 - ALL DOORS Cut four pieces of the larger vinyl [FF] 1/ 2" longer than the horizontal opening and trim the ends on a 45° angle. Install the top exterior vinyl starting at both ends and working toward the middle. Be careful not to stretch the vinyl.
Need help?
Do you have a question about the Alumax Bath Enclosures STIKSTALL 795 Series and is the answer not in the manual?
Questions and answers