Advertisement
Operating Instructions and Parts Manual
WHEN USING YOUR PARTS WASHER
1. Wear suitable protective clothing, gloves and goggles.
2. Clean off any accidental splashes of degreaser on
skin immediately, following the degreaser manufac-
turer's instructions carefully. Seek medical attention
if necessary.
3. Keep work area tidy and mop up any accidental
spills of degreaser.
WHEN NOT IN USE
1. Switch off pump, close the lid and disconnect from
the electrical supply.
2. Disconnect from the electrical supply before carry-
ing out any maintenance or cleaning on the parts
washer.
WARNING
The pump of your parts washer may be damaged
if you use solvents like perchloroethylene or
trichloroethylene.
ELECTRICAL CONNECTIONS
Plug into a standard 120 volt grounded plug.
WARNING
This appliance must be grounded.
OPERATION
Always wear protective clothing, gloves and goggles
when using your Parts Washer.
1. Open the parts washer lid and place parts to be
washed on the parts shelf.
2. Position the flexible nozzle so that it is directly
above your parts.
3. Turn the power switch to the ON position.
4. Clean parts as needed.
5. Turn power switch to the OFF position.
6. Keep work area tidy and mop up any accidental
spills of degreaser.
WARNING
Clean off any accidental splashes of degreaser
on skin immediately, following the degreaser
manufacturer's instructions carefully.
Seek medical attention if necessary.
3-1/2 GALLON (13L) PARTS WASHER
MAINTENANCE
1. The lid incorporates a fusible link to close the lid
in the event of a fire. This link is non-resetting and
must be replaced once it has been triggered.
2. Make sure the holes in the removable parts shelf are
free of debris.
3. Do not allow the level of liquid in the parts washer
to fall below the pump inlet, as damage to the pump
can result.
4. Change degreaser as needed.
TROUBLE SHOOTING
The only trouble you should ever experience with your
Parts Washer is reduced volume flow or no flow of
cleaning liquid from the flex hose nozzle. The probable
cause is:
1. Foreign matter in the flex hose.
2. Low fluid level (not reaching the pump inlet).
3. Blocked/dirty filter.
4. Air in the pump. You can turn on and turn off the
parts washer for several times or knock on the
pump housing for several times to fix this problem.
Limited 90 Day Warranty
This warranty excludes incidental/consequential
damages and failures due to misuse, abuse or normal
wear and tear. This warranty gives you specific legal
rights, and you may also have other rights, which vary,
from state to state. OEM will not be responsible for any
consequential or incidental damag-es arising from the
breach of this or any other warranty, whether
expressed, implied or statutory. Some states do not
allow the exclusion or limitation of consequen-tial or
incidental damages, so the above exclusion may not
apply to you. This warranty gives you specific legal
rights, and you may also have other rights which vary
from state to state.
ALWAYS WEAR SAFETY GOGGLES.
3
24800
Advertisement
