Advertisement
Advertisement
Related Manuals for X-POWER 8885741
Summary of Contents for X-POWER 8885741
- Page 1 8885741...
-
Page 2: Table Of Contents
2 00 PSI Pressure Washer Table Of Contents Topic Page # Important Safety Tips, Precautions, Warnings, and Usage Instructions Assembly Instructions Operating Instructions 8-11 Detergents 11-13 Clean-up and Storage 13-15 Cleaning Tips 15-16 Technical Data Troubleshooting Tips Limited Warranty 18- 19 Parts 20- 26... - Page 3 2 00 PSI Pressure Washer GROUND FAULT CIRCUIT INTERRUPTER (GFCI) This pressure washer is provided with a ground fault circuit interrupter (GFCI) built into the plug of the power supply cord. This device provides additional protection from the risk of electric shock. Should replacement of the plug or cord become necessary, use only identical replacement parts that include GFCI protection.
- Page 4 2 00 PSI Pressure Washer IMPORTANT SAFETY PRECAUTIONS WARNING: When using this product, basic precautions should always be followed, including the following: Read all instructions before using the product. Save all safety instructions. Do not operate the pressure washer when fatigued or under the influence of alcohol or drugs.
- Page 5 2 00 PSI Pressure Washer Read all instructions included with the mask so you are certain the mask will provide the necessary protection against inhaling harmful vapors. Before starting the pressure washer in cold weather, check all of the parts of the equipment and be sure that ice has not formed.
- Page 6 2 00 PSI Pressure Washer electrical rating not less than the rating of the product.Examine the extension cord before use. Do not use damaged extension cords! Do not pull on cord to disconnect from the receptacle. Always disconnect by pulling on plug. Keep the cord away from heat and sharp dges.
-
Page 9: Assembly Instructions
2 00 PSI Pressure Washer Step 4 Attach the hose connector to pressure washer. Before attaching the connector to the male fitting, remove the plastic cap, which is inserted onto the male fitting on the pressure washer before shipping. This plastic cap can be discarded once removed. After both components have been installed, attach the garden hose with connector screw on the pressure washer. - Page 10 2 00 PSI Pressure Washer Connect the high pressure hose to the high pressure outlet fitting as per assembly step #3. Open the water supply valve completely. Before turning the unit on, press the gun trigger to bleed all the remaining air out of the pump and hose.
- Page 11 2 00 PSI Pressure Washer Gun Safety Lock This pressure washer is equipped with a gun trigger safety lock. When not using the pressure washer, use the safety lock to protect from accidentally engaging the high pressure spray. Adjustable Spray Nozzle The 4 IN 1 adjustable nozzle will allow you to use a variety of spray patterns from a full fan spray to other spray.
-
Page 12: Detergents
2 00 PSI Pressure Washer FIGURE B FIGURE A Low Pressure Setting High Pressure Setting ADJUSTING THE PRESSURE To adjust the pressure,proceed as follows: Low Pressure Setting 1. Hold the shaft of the lance in one hand. 2. Turn the grey part of the nozzle clockwise to obtain the high pressure. -
Page 14: Clean-Up And Storage
2 00 PSI Pressure Washer High Pressure Setting CLEAN-UP AND STORAGE Shutting Down the Pressure Washer WHEN FINISHED USING THE PRESSURE WASHER,FOLLOW THESE STEPS TO SHUT DOWN THE UNIT: Turn the pressure washer to the OFF position. Turn off the water supply. Before disconnecting high-pressure hose connection, point the gun in a safe direction and discharge the high-pressure water. - Page 15 2 00 PSI Pressure Washer Drain the detergent reservoir and flush with running water. Wipe away any remaining water on all parts and fittings. Engage the gun safety lock. Store the pressure washer, parts, and accessories in an area with a temperature above 0°C (32°F). Winterizing and Long-Term Storage FOLLOW ALL OF THE ABOVE SHUT-DOWN PROCEDURES,ADDING THE FOLLOWING STEPS….
-
Page 16: Cleaning Tips
2 00 PSI Pressure Washer CLEANING TIPS WARNING: ALWAYS TEST THE SPRAY IN AN AREA FREE AND CLEAR OF PEOPLE AND OBJECTS BEFORE YOU AIMING AT THE INTENDED CLEANING SURFACE. Wood and Vinyl Decks Rinse deck and surrounding area with fresh water. If using detergent, fill the detergent reservoir and apply to the area being cleaned at low pressure. -
Page 18: Troubleshooting Tips
... -
Page 19: Limited Warranty
Limitations on the Warranty This limited warranty does not cover: (a) normal wear and tear; (b) damage through abuse, neglect, misuse, or as a result of any accident or in any other manner; (c) damage from misapplication, overloading, or improper installation; (d) improper maintenance and repair;... - Page 20 2200 PSI Pressure Washer EXPLODER VIEW...
-
Page 21: Parts
2200 PSI Pressure Washer... - Page 22 2200 PSI Pressure Washer PART# DESCRIPTION Moto Assy Moto Hexagon Socket Head Cap Screw Plain Washer Deep Groove Ball Bearing Pump Pedestal Assy Big Gear O-Ring 64.77x2.62 Gear Shaft Pump Pedestal Oil Seal Deep Groove Ball Bearing Wobble Plate 11。 Wobble Plate Screw (Left) Thrust Bearing Assy Thrust Bearing Thin Board...
- Page 23 2200 PSI Pressure Washer PART# DESCRIPTION One-Way Valve Assy One-Way Valve Seat One-Way Valve Spring One-Way Valve Door One-Way Valve Cover One-Way Valve Cover O-Ring 9x1.8 Inlet Assy O-Ring Inlet Tube Plain Washer Hexagon Socket Head Cap Screw M5x16 Mainifold Assy Slotted Cheese Head Screws Small O-Ring Hexagon Socket Head Cap Screw M5x35...
- Page 24 2200 PSI Pressure Washer PART# DESCRIPTION Self-Priming Outlet Pipe O-Ring 11.4x2.1 Vebturi Nozzle ø1.5 U-Pin TSS Switch TSS Round Jacket Cable Jacket TSS Lead Wire Plastic Jacket (Soft) Plastic Square Jacket (Soft) Plate (Line) Receptacle Lever Sheath Spill Valve Assy Steel Ball Cover Steel Ball O-Ring 8.75x1.8...
- Page 25 2200 PSI Pressure Washer PART# DESCRIPTION Back Housing Assy Back Housing Cross Pan Head Tapping Screw ST4x19 Back Cover Accessory Water Gun Rack Cross Pan Head Tapping Screw 4x16 Hexagon Socket Head Cap Screw 5x30 Cross Pan Head Tapping Screw 4x16 Motor Cover Assy Motor Cover Main Switch With Shiled...
- Page 26 2200 PSI Pressure Washer PART# DESCRIPTION Hose Reel Big Stents (Right) Hose Reel Small Stents (Right) Hose Reel Small Stents (Left) Cross Pan Head Tapping Screw ST4x16F Cross Pan Head Tapping Screw ST4x10F High Pressure Joint U-Pin Cross Pan Head Tapping Screw ST4x16C Handle Assy Cross Pan Head Tapping Screw ST4x16F Cross Pan Head Tapping Screw ST4x10F...
Need help?
Do you have a question about the 8885741 and is the answer not in the manual?
Questions and answers