Responding To Error Messages - Canon EOS REBEL T8i Advanced User's Manual

Responding to Error Messages

When an error occurs, display the details of the error by following one of the procedures
below. Then, eliminate the cause of the error by referring to the examples shown in this
chapter.
On the [View info] screen, press <
Select [Error details] on the [Wi-Fi on] screen.
11 12
65 66
127 141
Note
When an error occurs, [Err**] is displayed in the upper right of the [Wi-Fi/
Bluetooth connection] screen. It disappears when the camera's power is set to
< >.
11: Connection target not found
In the case of [ ], is Camera Connect running?
• Establish a connection using Camera Connect (
In the case of [
• Start the EOS software and reestablish the connection (
In the case of [
• Turn on the printer.
Are the camera and the access point set to use the same password for
authentication?
• This error occurs if the passwords do not match when the authentication method for
encryption is set to [Open system].
Check upper- and lower-case letters, and make sure the correct password for
authentication is set on the camera (
12: Connection target not found
Is the power of the target device and access point on?
• Turn on the target device and access point, then wait a while. If a connection still
cannot be established, perform the procedures to establish the connection again.
21 22
67 68
142 151
], is the EOS software running?
], is the power of the printer on?
>.
23
69
152
).
).
613
61 63
91 125
).
64
126