Table of Contents
Advertisement
Chengdu Ebyte Electronic Technology Co,;Ltd
9.1 Download Program
Key word
The module is SOC with GPIO port. For program downloading, please use the special downloader of CC series:
JTAG (or the original CC1310 board from TI), any other serial port or ISP, ICP are unavailable to download. Below
is the connection diagram of JTAG （XDS100） . See more details in TI official document.
Input program
10. Hardware design
It is recommended to use a DC stabilized power supply. The power supply ripple factor is as small as possible, and
the module needs to be reliably grounded.；
Please pay attention to the correct connection of the positive and negative poles of the power supply. Reverse
connection may cause permanent damage to the module；
Please check the power supply to ensure it is within the recommended voltage otherwise when it exceeds the
maximum value the module will be permanently damaged；
Please check the stability of the power supply, the voltage can not be fluctuated frequently；
When designing the power supply circuit for the module, it is often recommended to reserve more than 30% of the
margin, so the whole machine is beneficial for long-term stable operation.；
The module should be as far away as possible from the power supply, transformers, high-frequency wiring and other
parts with large electromagnetic interference.；
Copyright
©2012–2019
26
manual
Connection diagram of JTAG downloader
Chengdu
，
Notes
unconnected）
Ebyte
Electronic
E70-868T30S user
（TDI and TDO pin can be
Technology
Co,;Ltd
Advertisement
Table of Contents
