Specifications
FuseConnect-MPO
Assembly Manual
Note: During fiber preparation, broken fiber may get injure the eyes or
other parts of the body. Always wear eye protection when handling optical
fibers and dispose of any cut or cleaved ends properly.
1. Connector components and tools
Fuseconnect-MPO is assembled with the parts shown below.
1.1. Connector unit
Housing assembly
Mechanical
clamp
Body
1.2. Assembly tools
Fusion splicer (60R)
Mechanical sleeve installer base
2. Fiber preparation tools
Fiber Cleaver (CT-30)
3. Operation Procedure
3.1. Preparation
3.1.1. Insert boot
überreicht durch:
Opternus GmbH
optische Spleiss- und Messtechnik
Connector holder
Mechanical
clamp
Boot unit
cover
Fiber holder (FH-50-12)
Mechanical sleeve press
Fiber Stripper (HJS-02)
Insert boot unit through the ribbon
fiber.
Opternus GmbH Optische Spleiss- & Messtechnik
Bahnhofstr. 5
Tel. +49(0)4532-20 44-0
D-22941 Bargteheide
Fax +49(0)4532-20 44-25
E-Mail: info@opternus.de - www.opternus.de - www.opternus-shop.de
3.2. Cable Processing
3.2.1. Strip fiber
35mm
Set ribon fiber on
Set fiber holder on fiber
fiber holder
stripper
Note:There is no gap
between fiber holder and
stripper
3.2.2. Cleaning; screening
Clean the fiber surface after the coating is removed with cotton dipped in alcohol.
Bend the fiber up and down, left and right 3 times slowly with the finger (about
60 ) to verify that it does not break.
3.2.3. Cleave fiber
Note: There is no gap
Set fiber holder on cleaver
between fiber holder and
cleaver
3.3. Fiber Termination
3.3.1. Preparation
3.3.2. Fusion splice
Specifications and descriptions are subject to change without prior notice.
Büro Süd:
Wäldenbronner Str. 2
D-73732 Esslingen
Strip ribon fiber
10mm
Cleave fiber leaving
10mm of bare fiber
Set fiber holder and connector
holder on fusion splicer
Splice cable to connector
Tel. +49(0)711-3 10 59 99-0
Fax +49(0)711-3 10 59 99-99
Need help?
Do you have a question about the FuseConnect-MPO and is the answer not in the manual?
Questions and answers