Advertisement
Before and after use
- Check all screws and fittings are secure before giving to a child.
- Ensure all locking devices are engaged. Ensure there are no broken components.
Assembly Instructions:
1. Loosen the clamp and slide the handlebar stem over the fork column until it touches
the lock nut.
2. Ensure that the handlebars are aligned with the front wheel and that the wheel is
facing forwards (note the arrow on the front fork)
3. Tighten the upper bolt one quarter of a turn, the middle bolt one quarter of a turn and
then the lower bolt one quarter of a turn using the hex key provided. Repeat until the
clamp is tight and the handlebars are secure.
WARNING! Failure to tighten the clamp fully will result in the handlebars not being
secure and the scooter will be unsafe to ride. Over tightening one bolt before the
other will make it impossible to tighten the clamp fully.
Use
- Hold both handgrips firmly. Put one foot towards the front of the deck, push off the
ground to propel the scooter forward with other foot. Both feet can fit on the deck when
desired speed has been reached.
- Braking: Brake is located at the rear, when necessary, press down on it to slow down.
Press down gradually in order to prevent skidding or loss of stability. The metal or
aluminum brake may heat up after multiple uses. Avoid touching it during and after use.
- Shoes are mandatory and we strongly advise you to wear long pants and long sleeve
shirts to avoid injury if you fall.
2
Advertisement
