Sportwerks E-RACERS RECOIL Getting Started

Advertisement

Quick Links

GettinG started
Note: Before you start running your new Recoil, it
is absolutely necessary that you read through
all of the operating instructions to prevent
unnecessary damage and get the maximum
enjoyment from your vehicle.
Step 1
Plug the AC charger into the proper wall receptacle
(110V). Plug the battery pack into the charger and let it
charge for 3 hours for the first time. After running, or
when your Recoil slows noticeably, recharge the battery
pack for 5–6 hours for a full charge.
Step 2
Remove the transmitter battery cover by sliding the cover
from left to right. Install eight (8) AA batteries into the
battery holder. Pay close attention to the correct direction
of the positive (+) and negative (-) ends as marked in the
tray. Once all 8 batteries are in place, reinstall the battery
cover by sliding it on from right to left.
Step 3
®
Fig. 1
Fig. 2
Insert the antenna wire through the antenna mount and
into the antenna tube (Fig.1) pushing it through until it
comes out the other end. Push the antenna tube (Fig. 2)
into the antenna mount.
Step 4
Fig. 3
1

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the E-RACERS RECOIL and is the answer not in the manual?

Questions and answers

Summary of Contents for Sportwerks E-RACERS RECOIL

  • Page 1 ❑ Step 3 ® Fig. 1 GettinG started Note: Before you start running your new Recoil, it is absolutely necessary that you read through all of the operating instructions to prevent unnecessary damage and get the maximum Fig. 2 enjoyment from your vehicle. ❑...
  • Page 2 ❑ Step 6 Fig. 4 Once the transmitter has been turned on, power up Fig. 5 the Recoil by sliding the switch on the speed controller to the “ON” position. If the rear wheels turn, adjust the “TH Trim” knob located to the lower right of the steering wheel until they stop.

Table of Contents