Page 1
Shower head (A) Shower head (B) Mounting Guide Mounting Plate Lock Nut Washer Shower Nipple Wall Mount / Toggle Screw Note: The shower head/spout is approximately 11 lbs 350 Dewitt Avenue, Brooklyn, NY 11207 USA T: 718.257.2800 F: 718.257.2144 E: info@watermark-designs.com...
Page 2
WALL 1A. Detach the mounting plate from the backside of the shower head/ spout by unscrewing the two allen screws (mounting screws) located on the bottom side of shower head/spout B (refer to parts list view) 1B. Connect the shower nipple to the supply line, followed by the mounting guide.
Page 3
3A. Drill wall with a hole size of 21/64'' with a maximum depth of 1 11/32''. This depth will allow the lock nut to fasten the mounting plate until it braces the wall. See below for detailed diagram 3B. Once the hole has been drilled, remove the mounting plate from the wall to insert the wall mount screws into the wall.
Page 4
Wall Mount / Toggle Screw Application Wall Mounting Plate 11/32'' Wall Mount Screw MIN. Depth of Hole 1 11/32'' Washer / Lock Nut 4A. After securing the mounting plate onto the wall, remove the mounting guide from the shower head/spout nipple. 4B.