Table of Contents
Advertisement
Available languages
Available languages
RENEWAL OF BRUSH ASSEMBLIES
1. The main brush consists of a brush shaft with two
brush core assemblies fastened with six self-tapping
screws.
2. The brush cores can be replaced as below:
• Unscrew the self-tapping screws.
• Pull the brush core assembly to the front (broom
viewed from user side) to remove it from the brush
shaft.
NOTE: When reassembling the brush, ensure
the split pins are fixed in the holes to guide the
brush.
RUBBER SEALING APRONS
1. The rubber aprons prevent dust leakage produced
by the brush. To maintain performance, damaged
or used aprons must be replaced.
GREASING OF THE MAIN WHEELS
1. To clean and grease the wheel axle and gear ring,
the main wheels must be removed as described
below:
• Remove hood, remove the bolt and domed cap nut
from the wheel and pull the main wheel.
• Unscrew the gear cover and apply grease in the
gear area.
• Reposition the main wheel.
Compliance with our operating and maintenance
instructions will ensure trouble free and smooth
operation of the machine.
If you are not capable of performing the maintenance
schedule by yourself, please contact Uline Repairs.
PAGE 4 OF 15
MAINTENANCE
REPLACEMENT AND TENSIONING OF THE V-BELT
1.
2. Loosen the clamp screw and pull out the side brush
3. Place the V-Belt through the brush arm and put it on
4. Push the side brush back into the brush arm and
5. Place V-Belt into the groove of the righthand main
When the brush arm is down, the V-Belt must be
tensioned to allow a perfect drive transmission. If
necessary, retighten by shifting the side brush arm
bearing.
REPLACEMENT OF THE SIDE BRUSH
1. The side brush can be replaced after removing hex
REGAINING OF BRISTLES
1.
2. If the bristles have been bent outwards, bring them
MAINTENANCE SCHEDULE
MAINTENANCE INTERVALS
Daily
• Empty dirt box
• Clean the unit
• Check brushes and sealing aprons
Weekly
• Remove the ropes, tapes, etc., entangled in the
Monthly
• Grease the track wheels
• Check V-Belt tension; if necessary, retighten
Lift up the side brush arm.
from the brush arm.
the V-Belt pulley on the brush shaft.
retighten the clamp screw.
wheel.
bolts from the side brush.
If the bristles have been bent inwards in transit, the
side brush must be placed on a flat base with the
bristles pointing outward and a weight must be
placed on the plate. The bristles will regain their
correct position gradually.
together, wrap a rubber band around the bristles
and allow the band to stay for sometime. The bristles
will regain their correct position gradually.
main brush shaft
0715 IH-2760
Advertisement
Table of Contents
