Measure And Cut All The Tap Holes Before Fitting The Taps Section 1 - Tap Installation Instructions 1.1 - Hydrotap Tap Installation - Zenith HydroTap G4 Installation Instructions Manual

Special Tools Required:
In addition to normal tools, the following will be required:
For the standard taps:
• 35mm diameter sheet metal hole punch for sink tops. (Not supplied)
• 35mm diameter hole saw for timber bench tops. (Not supplied)
• Nut runner tube spanner (supplied) for fixing tap assembly.
• Jig saw for ventilation cut outs
When installing a font, the following will be required:
• 140mm diameter sheet metal or hole saw to suit surface being cut.
Hole positioning:
Position the tap such that it dispenses into the sink bowl with ample clearance for a cup or tea pot. Alternative-
ly, the tap could be mounted away from the sink using a Zenith Font, available as an accessory.
TAP
Elite
HydroTap Classic
HydroTap Arc/Cube
** Check bowl depth and adjust accordingly
35mm hole
802261NZ - Residential HydroTap - CO Installation Instructions - 11.16 - v2.01
Section 1
Tap Installation
Recommended
dispensing distance
116 mm
116 mm
171 - 174 mm (Extended) **
Sink
116
BC HydroTap
Page 9 of 20