Getting Started - Adafruit Motor Shield V2.0 Manual

Arduino Pin
D7
D8
D9
D10
D11
D12
D13
Note
D8~D13 was used by Motor Shield. Please don't use those pins to avoid conflict.
Analog Pin Used
Arduino Pin
D0
D1
D2
D3
D4
D5
Note
Not Used means you can use those pins freely.

Getting Started

Here we will show you how to drive a dc motor and a stepper with this shield.
We need a Seeeduino V4
board, and you can use an Arduino as well.
And you need a dc motor or a stepper for testing.
Download the library
Click the below button to download the library. If the library you had download include
"-master", please remove it.
as the controller, Seeeduino V4 is an Arduino compatible
Function
Not Used
OUT1
Enable of Channel0
Enable of Chennel1
OUT2
OUT3
OUT4
Function
Not Used
Not Used
Not Used
Not Used
Not Used
Not Used