Needle Replacement - Crosley CR6016A Instruction Manual

English
Platter Auto-stop
If the Auto-stop Switch is set to ON position, the platter will stop spinning
automatically when the record plays to the end. In some rare occasion, if the
turntable stops playing before the end of the record, set the switch to OFF
position the turntable should overcome this issue.
Adjustment if Tonearm Stops too early
If the platter stops before the tonearm reaches the end of the record, you can
adjust it by following the below steps:
1. Disconnect the turntable from the power supply.
2. Insert a screwdriver into the Auto-stop Adjustment Hole and locate the
tuning screw inside.
3. If the tonearm stops earlier than the end of the record, rotate the screw
clockwise by approximately ¼ turn only.
4. Reconnect the turntable to the power supply.
5. Replay the record to see if the adjustment has been successful. If not, repeat
steps 1-4, but only rotate slightly to perform the fine adjustment. Rotate the
screw counter-clockwise if the tone arm fails to stop. Repeat this fine
adjustment process until the tonearm will stop at the correct finish point.

Needle Replacement

Removing Needle
1. Gently pull down the front edge of the needle.
2. Pull needle forward.
3. Pull out and remove.
Installing Needle
1. Position the needle with its tip facing down.
2. Line up the back of the needle with the cartridge.
3. Insert the needle with its front end at a downward angle and gently lift the
front of the needle upward until it snaps into place.
7